Sensor ALARM KEYPAD Guide de l'utilisateur télécharger pdf (Page 37)

Siren Features and Operation

Digital Life User Manual | Page 27 of 62 ATT-UM-V1.1-201303

Siren (SW-ATT-SRN) Operation

The LIGHT shows the system status, as follows:

• Solid Green—unit is AC powered and backup battery is good.

• Blinking Green—unit is not AC powered and is operating on batteries.

• Solid Red—unit is AC powered and the backup battery needs to be replaced.

• Off—unit is not AC powered and backup battery has failed.

Replacing the Siren (SW-ATT-SRN) Batteries

Your Siren (SW-ATT-SRN) is equipped with two (2) non-rechargeable 3VDC (Duracell

DL123A or Panasonic

CR123A) batteries. The batteries provide twenty-four (24) hour

battery backup. You must first remove the unit from the AC outlet by removing the

retaining screw that is located at the top of the siren which secures the siren to the AC

outlet. Then you can replace batteries by opening the battery compartment located on

the rear of the unit.

After you have installed new batteries, plug the siren back into the lower socket of the

AC outlet. Then replace the retaining screw in the plastic tab at the top of the siren and

secure the siren to the AC outlet.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 71 72

Pas de commentaire

Sensor ALARM KEYPAD Guide de l'utilisateur Page 37